High Pressure 12 volt 14 bar 10L/m Diaphragm Pump.

Perfect for portable car wash machines, carpet cleaning machines, sweepers and agriculture sprayers and patio misting systems, and general mobile water transfer. etc

Power supply: 12 volt DC.
Max Flow: 10 L/min. (2,6GPH)
Max Pressure: 14 bar pressure. (200psi)
Amps: 15 amp version.
Recommended fuse size: 15 amps.
Self priming pumps up to 1,5 metre.
Controlled by auto pressure switch.
XDP pump connectors – 1pc 3/4″ Male Thread ,1pc 1/2” hose barb , 1pc 1/2″ hose barb pre filter.
Automatic flow controller.
XDP series design based on a 5 chamber Diaphragm.

XDP high pressure diaphragm pump, and can run dry without damaging the motor.

Caution:

Intermittent use only – 30 minutes ON and 20 minutes OFF. It needs to cool down to ambient temperature.
Frequent start/stop cycling should be avoided.
Possible reasons for causing failure – Leaks on the system will cause the pump to cycle, this leads to Pressure Switch failure. Examples: poor connection, Gardena fittings, Ball valve or taps not closing properly.
Low voltages will force these pumps to run continuously and not reach the cut-off pressure of 13 bar, resulting in pump motor burn-out.

WARNING:

High resistance of these pumps will lead to burning out of the brush pump if used continuously.
Pump pressure 200PSi (14 bar) with self-priming ability.
XDP High-Pressure wash pumps use Viton seals widely for liquid PH value vary between 4-11PH.

Note:

Because of the high pressure, clamps should be used to secure tubing.
Rubber feet fitted for noise and vibration reduction.
Small, Portable & lightweight.
Mount in a vertical position and use flexible high pressure hose.
Shaft made of Stainless steel for heavy-duty pressure.

Additional information:

Weight: 5 kg.

Dimensions: 25 × 13 × 13 cm.

HIGH PRESSURE 12 VOLT 14 BAR 10L/M DIAPHRAGM PUMP